一．電器性能規格?。?/span>LERICAL  CHARAERISTICS

測試條件   Test  Conditions

在微小電流(100mA )以下測試

Measured  at  all l current (100mA or less)  1000HZ

輸入500V電壓1分鐘,按以下方式測試:Apply a voltage of 250V DC for 1 min to following portions  after mhich measurement shall be made:

(1)    塑膠體與針腳之間  (1)Between  body  and  conduor

(2)    不接觸的針腳之間  (2)Between  conduor  not  to  be conta

輸入AC500V(50-60HZ)電壓,1分鐘感應電流為0.5MA,按以下方法測試:

AC 250V ims(50-60HZ) for 1 min trip current: 0.5 mA

(1)塑膠體與排腳之間  (1)Between  terminals

(2)不接觸的排腳之間:  (2)Between  individual terminals and frame

-25℃----+75℃

在沒有指定的情況下測試溫度,濕度,氣壓如下:

Unless otherwise specified , the stardard range or atmospheric conditions  for making measurements and tests are as follows

(1)    溫度為5℃--35℃       (1)Ambient temperature:5℃to  35℃

(2)    濕度為45%--85%       (2)Relative humidity :45% to 85%

(3)    氣壓為80KPA----106KPA (3)Air pressure : 80Kpa  to  106Kpa

二.機械性能規格  MECHANICAL  CHARAERISTICS

在排腳前端任意一個方向的先端加上300克力力度測試，時間為15秒

A static load of 300gf shall be applied to the tip of the terminal for 15 sec in any direion

負荷：在負荷的條件下以每分鐘25-30回的頻率進行100,000次的負荷測試;

Aswitch shall be subjeed to 100.000 cycles at a speed of 25-30 cycles for 1 min